KTM 690 Enduro Rally Raid Evo 2 Tank Kit 2014/2016

RRP 262-250x250.jpg
RRP 260-250x250.jpg
RRP 262-250x250.jpg
RRP 260-250x250.jpg
sold out

KTM 690 Enduro Rally Raid Evo 2 Tank Kit 2014/2016

849.04

*** EVO 2 TANK KITS ARE SPECIAL ORDER ONLY ***

Our new EVO2 Tank Kits have been CAD designed to fit all 2014/16 KTM 690 Enduro Models, and hold an extra 10 litres capacity of fuel, ideal for the longer trips or rallies.

Width with tanks fitted, measuring at triple clamp is 450mm. 2014/16 standard KTM 690 is 400mm.

These are rotational-moulded in Polyethylene, in either Black, Orange, White or Natural (semi-opaque) and come complete with all fixings required to fit the kit.

The fuel tanks are connected into the OEM rear tank using our billet adaptor system,  which has been proven successfully over the last 3 years with our previous kits.

Each tank is fitted with its own fuel tap, so they can be independently turned on or off. Both tanks are supplied with Acerbis Cap & breather.

Complete with all necessary fixings, so bike can be returned to standard, if required when the kit is removed.

No disruption to the OEM air filter cover,  seat removal is not affected, and does not interfere with filter maintenance.

Both tanks are very easy to remove in a couple of minutes, for routine maintenance.

Designed to work in conjunction with our  Foam Air Filter Kit RRP 010.

It is not possible to fit our Engine Toolbox Kit(RRP 076) with this 2014/15 EVO2 Tank Kit.

If tanks ONLY are fitted, then you will require our Tank Shroud Kit (available separately) in either Orange, White or Black.

These tank kits are designed to work best with our own Radiator Screen RRP 095, but the OEM plastic screen can be cut down and used, if required.

These tanks have been designed to fit with our Radiator Protector RRP 150(available separately).

All our tanks have been race-tested on most major rallies around the world, and as such, we are confident that they will survive most efforts to damage them, in the event of a crash impact.

Due to the nature of the rotational moulding process, this can cause slight scratching and surface blemishes.Although these do not affect the performance of the tank, we supply a perforated plain colour graphic panel to go on the outside of the tank.

We also have a section of heat-resistant adhesive silver tape on the underside of the left tank to minimise heat transfer from the header pipe.

They are also chemically Fluorinated after moulding, this ensures that the tanks do not leach vapours through the plastic, which can cause "sweating" of the tanks and also causes graphics to lift off over time, this is a process which is not used by many other after-market tank manufacturers.

The fitment of our tank kits does not require the removal, or modification of any of the KTM electrical sensors or wiring.

All our tank kits, although normally in stock, are built to order, depending on colour & kit specification, and can take up to 12 working days to despatch, from receipt of order.

Total fitted weight 4Kgs.

NOTE: WHEN FITTING THIS KIT TO A US/CANADA SPEC BIKE, YOU MUST REMOVE THE EMMISIONS CANISTER

 

Color:
Add To Cart